SECO-LARM enforcer 300L Owner's Manual download pdf (Page 5)

ENFORCER 300C/L Owner's Manual

Page 5

When you press button #1 to arm the alarm,

and the alarm responds with three chirps and

three light flashes, there are two possibilities:

A. Delayed domelights — If your domelights

do not immediately turn off when you

close your car door (in other words, your

vehicle has delayed domelights), this is

normal. The alarm should protect all the

openings once the domelights go off.

B. A zone was bypassed — In other words,

the alarm has armed, but a hard-wired

door is not protected (either because it is

open, or because its pin switch is broken).

ZONE BYPASS

If the bypassed door is later closed, it will

be restored (no siren chirp or light flash).

If your alarm indicates a bypassed zone, find

the cause as soon as possible to ensure your

vehicle is completely protected. For instance,

if your driver's door is not properly closed

when you arm your alarm, a thief could open

any door without setting off the alarm.

NOTE — The three zone bypass confirm

chirps will not sound if chirp delete is

engaged. However, the parking lights will still

flash three times. See CHIRP DELETE, page 7.

SENSOR BYPASS

This is useful if you know, based on

experience, that your shock, glass-break, or

other add-on sensor will false trigger, such as

when you park near a construction site.

To bypass your alarm's sensors, first press

button #1 to arm the alarm (even if the alarm

is set for passive arming). The siren chirps

and the parking lights flash once (three times

if a zone is bypassed) to confirm armed.

Within three seconds, press button #2. The

siren chirps three times and the parking lights

flash three times to confirm sensors are

bypassed. The sensors are automatically

restored the next time button #1 is pressed.

→

→

→

→

To trigger the alarm in an emergency (armed

or disarmed), press and hold transmitter

button #1 for 3 seconds. The siren sounds

and the parking lights flash about 30

seconds. You can also stop the siren and the

EMERGENCY CALL FOR HELP (Panic)

parking lights by pressing

button #1 again. When panic

is activated, the alarm will

disarm and doors will unlock (if

remote controlled door locks are connected).

ARMED

When the 30-sec. arming countdown ends, or

when transmitter button #1 is pressed to arm

the alarm, the siren chirps and parking lights

flash once, and the LED starts

flashing to show the alarm is

armed.

1 2 3 4 5 6 7 8 9 10 11 12

Comments to this Manuals

No comments